Remove a back wheel.

Disconnect a forward support of a disk brake.

Fig. 3.117. Removal of a brake disk

Remove a brake disk (fig. 3.117).

Fig. 3.118. Check of a gap in the hug bearing of a back wheel

Install the indicator of hour type against a nave of a wheel (fig. 3.118).

Moving a wheel nave manually in the axial direction, measure a gap in the hug bearing.

At most: 0,05 mm.

If the gap exceeds a maximum replace the bearing.

ATTENTION Performance of the following procedures without preliminary removal of the sensor of speed of a wheel of anti-blocking system of brakes can lead to break of a chain in a plait of wires if the plait is by mistake tense. Before performance of the following operations remove the sensor of speed of a wheel of anti-blocking system of brakes (from a body) and fix it in the suitable place where the sensor will not be by mistake damaged when performing service.