Merge oil from the transmission.

Remove the sensor of anti-blocking system of brakes.

Fig. 3.126. Removal of the spherical hinge of a steering rod end of draft

By means of special adaptation remove the sharovy hinge of a steering rod end of draft (fig. 3.126).

Fig. 3.127. Removal of the spherical hinge of the lower back lever

By means of special adaptation remove the sharovy hinge of the lower back lever (fig. 3.127).

Fig. 3.128. Removal of a support of the back brake mechanism

Remove a support of the back brake mechanism and suspend it on a wire (fig. 3.128).

ATTENTION Sharp edges of a connecting shaft can cut or punch an epiploon. Be careful at separation of a connecting shaft from the transmission.

Extend a connecting shaft directly.

Fig. 3.129. Installation of special device for keeping of a semi-axial gear wheel

Install the special device for keeping of a semi-axial gear wheel after removal of a connecting shaft in the transmission.

Remove other components and establish as it should be, the return to removal.

Fig. 3.130. Installation of a new clip on a connecting shaft

Before installation deliver on a connecting shaft a new clip a cut (fig. 3.130) up.

After installation measure outer diameter.

If it exceeds norm, repeat installation with use of a new clip.

Maximum outer diameter: 31,2 mm.