6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)

Отсоединение разъема вакуумного шланга
Fig. 6.11. Detachment of the socket of a vacuum hose


Disconnect the socket of a vacuum hose from the amplifier of brakes, pressing uvulas of the socket of a vacuum hose (fig. 6.11).

Снятие хомута
Fig. 6.12. Removal of a collar


Remove a collar, using flat-nose pliers, and disconnect a vacuum hose from an inlet collector (Z6) (fig. 6.12).

Отсоединение вакуумного шланга от впускного коллектора
Fig. 6.13. A detachment of a vacuum hose from an inlet collector


Insert the thin screw-driver with flat shliyets in the point designated by an arrow in the figure 6.13, displace a ring down and disconnect a vacuum hose from an inlet collector (LF).
Remove a vacuum hose.
Establish as it should be, the return to removal.
Make sure that the vacuum hose is inserted so that connection of a vacuum hose concerns a ring of an inlet collector (LF).
Insert the socket of a vacuum hose in the amplifier of brakes.
Make sure that the vacuum hose is established reliably, having pulled for it, and again insert it in the amplifier of brakes.

Установка катушки усилителя тормозов
Fig. 6.14. Installation of the coil of the amplifier of brakes


Make sure that the coil of the amplifier of brakes is in the socket of a vacuum hose (fig. 6.14).