Perform each procedure (1-3) during 10 with, otherwise the procedure of installation of a code will be stopped.

1. Install the ignition switch in position of ACC, and then switch off the audioblock.

2. At first press the AUTO-M button, then at the same time press the button of channel 6 approximately on 2 with until on the display indication of "CODE" appears.

Fig. 7.76. Scheme of cancellation of the coding 1

3. Press the AUTO-M button again, then at the same time press the button of channel 6 until on the display rectangles appear.

4. Buttons of the choice of channel 1-4 are used for input of the operating code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. You enter number during 10 pages. If indication on the display disappears, repeat procedures starting with the first.

Fig. 7.77. Scheme of cancellation of the coding 2

Fig. 7.78. Scheme of cancellation of the coding 3

NOTE The procedure 5 has to be performed during 10 from later procedure 4.

5. During display of a code, press the AUTO-M button, then at the same time press the button of channel 6 approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages. After indication disappears, number of a code will be removed.

Fig. 7.79. Scheme of cancellation of the coding 4

6. If on the display there is an indication of "Err" (mistake), repeat the procedure since 4.