If system of safety cushions and prednatyazhitel of seat belts on front seats are in good repair, the signaling device of malfunction has to light up at turn of the switch of ignition in the provision of "ON" (ignition is included) or at inclusion of a starter. Then, after a while, the signaling device will go out.

If the signaling device burns constantly or at all does not join at turn of the switch of ignition in the provision of "ON" (ignition is included), means the system of safety cushions or prednatyazhitel of seat belts is faulty. In this case urgently address on the service station of the official dealer of Mazda. If the signaling device indicates malfunction, safety cushions or prednatyazhitel of belts can not work at the road accident.

If malfunction of system of pillows of safety / преднатяжителей seat belts is found and the malfunction signaling device burns, the sound alarm system of malfunction at the same time begins to function. Every minute the sound signal lasting about five seconds is distributed.

The sound alarm system of malfunction will work approximately within 35 min.

If the seat belt of the driver is not fastened and the speed of the car will exceed about 20 km/h, the visual signaling device will begin to blink and the sound signaling device will join. If the sound signaling device joined and the seat belt remains not fastened, the signaling device will work even if the speed of the car will become lower than 20 km/h. The sound signaling device will be switched off as soon as the seat belt or after the determined time is fastened.

Fig. 1.134. A visual signaling device of not fastened seat belt of a passenger seat

If the seat belt on a front passenger seat is not fastened and the switch of ignition is in the provision of "ON" (ignition is included), the driver and the passenger will receive the warning of it by means of visual and sound signaling devices. The visual signaling device lights up over a rear-view mirror (fig. 1.134).

If the seat belt of the forward passenger is not fastened and the speed of the car will exceed about 20 km/h, the visual signaling device will begin to blink and the sound signaling device will join. If the sound signaling device joined and the seat belt remains not fastened, the signaling device will work even if the speed of the car will become lower than 20 km/h. The sound signaling device will be switched off as soon as the seat belt or after the determined time is fastened.

NOTE To provide normal functioning of the sensor of loading which is built in a pillow of a front passenger seat to the passenger it is not necessary to sit on an additional pillow. Otherwise the sensor of loading will not be able to work properly. In the presence on a front passenger seat of baggage or pets the signaling device of not fastened seat belt can work and give a false signal.

Fig. 1.135. A visual signaling device of not fastened seat belt of a back seat

If seat belts on back sitting are not fastened and the switch of ignition is in the provision of "ON" (ignition is included), the driver and passengers will receive the warning of it by means of visual and sound signaling devices. The visual signaling device lights up over a rear-view mirror (fig. 1.135).

The signaling device can burn with red or green light. If the seat belt is not fastened, then the red signaling device burns. If the seat belt is fastened, the signaling device burns with green light. Visual signaling devices work even if on back sitting passengers are absent. The sound signaling device joins if to unfasten a seat belt.

NOTE If seat belts on back sitting are not fastened during the determined time after start of the engine, all visual signaling devices will be switched off.