d22f196b

2.2.7. Removal and installation of the power unit

Removal of a support No. 1
Removal of an arm of a support of the engine No. 4 and support of the engine No. 4
Installation of an arm of fastening of the engine No. 3
Installation of an arm of a support of the engine No. 4 and support of the engine No. 4
Installation of a support No. 1



Remove the rechargeable battery.
Remove a tray of the rechargeable battery.
Remove a radiator.
Merge oil
Remove the oil pump of the hydraulic booster with an oil filter, without disconnecting a hose and place it so that it did not disturb.
Remove the compressor of the air conditioning system, without disconnecting tubes. Place the compressor of the air conditioning system so that it did not disturb. For fixing of the compressor use a wire or a rope.
Remove the integrated shaft from an intermediate shaft of the drive.
Remove the air filter, an inlet air duct, an accelerator rope with an arm and a vacuum hose.
Remove the filter of the automatic transmission and a cable of the selector. (models with the automatic transmission).
Remove a vacuum hose and a hose of a heater.
Remove the working cylinder of coupling and a cable of management (model with the mechanical transmission).
Remove a plastic hose of supply of fuel.
Disconnect a plait of wires in a motor compartment.
Remove a forward pipe.

Fig. 2.89. Components of fastening of the power unit on the car: 1 – engine No. 1 support; 2 – engine No. 1 support arm; 3 – arm of a support of the engine No. 4 and support of the engine No. 4; 4 – the tire of connection of the engine with "mass" of a body; 5 – arm of fastening of the engine No. 3; 6 – the engine, the transmission in the block with the main transfer


Remove the power unit (fig. 2.89).