Fig. 2.86. Installation of special adaptation on a cam-shaft

Install special adaptation on a cam-shaft (see fig. 2.86).

Fig. 2.113. Lock bolt of a pulley of a bent shaft: 1 – bolt

Establish a lock bolt of M6x1,0 and tighten his hand (fig. 2.113).

Turn a bent shaft clockwise to cylinder No. 1 piston VMT.

Fig. 2.104. Installation of special adaptation on a bent shaft: 1 – special adaptation

Hold a pulley of a bent shaft special adaptation (see fig. 2.104).

Tighten a fixing bolt of a pulley of a bent shaft in two steps:

tighten a bolt the moment of 96-104 N · m;

tighten a bolt on 87-93 °

Turn off a bolt of M6x1,0.

Remove special adaptation from a cam-shaft.

Take out special adaptation from an opening of the lower cap of the block of cylinders.

Turn a bent shaft clockwise on two turns to cylinder No. 1 piston VMT. If the provision of VMT does not manage to be reached, weaken a fixing bolt of a pulley of a bent shaft and repeat the described actions at first.

Establish the lower cap of the block of cylinders and tighten its moment inhalings of 18-22 N · m.